Ultrak JPD-100, User Manual

Page: 10 / 124

518007-1960-G KEMU040018
January 2002
Sector ID
Sector IDs are used for labeling defined areas the SmartScan unit views. Up to
16 Sector IDs can be programmed and stored in each SmartScan unit. Sector
ID's are programmed using a KBD-100 Programming Keyboard and JPD-100
Controller.
Whenever the SmartScan unit is under manual control and viewing a
programmed Sector, the title of the Sector is added to the SmartScan video
signal. Note: The camera ID display must be enabled; if the camera ID display
is disabled, the Sector title is also disabled.
MultiCall
A CCU-100 Central Control Unit or a SSI-100 Small System Interface Unit is
required to program MultiCalls. A MultiCall is programmed to perform one or
more system functions at the same time or in series with programmable dwell
times between each function. The system functions that can be included in a
MultiCall are PreShots, VectorScans, video switching, turning on and off VCR's
or other auxiliary devices, or starting a MultiCall (including itself). MultiCalls are
used to define the system's automatic response to events such as date/time or
alarm inputs. MultiCalls can be started or stopped by an operator using the
keypads on the Controller or can be assigned to the function keys on the JPD-
100 Controller. A MultiCall can also be used to sequence cameras on monitors.
Up to 256 (00-255) MultiCalls can be programmed and stored with a 16-
character title in the CCU-100 Central Control. Up to 100 (0-99) MultiCalls can
be programmed and stored in the SSI-100 Small System Interface.