Ultrak JPD-100, User Manual

Page: 17 / 124

518007-1960-G
1-
2 KEMU040018
January 2002
1.2 INSTALLATION/SET-UP
CCU-100, CCU-100A, OR CCU-100HD CENTRAL CONTROL UNIT (CCU)
If the JPD-100 Controller is installed with a Central Control Unit, the controller
can be plugged directly into the front panel controller connector of the CCU. The
CCU front panel controller connector provides the +5Vdc required to operate the
JPD-100. Note: The firmware in the JPD-100 must be revision D or later for full
functionality of the CCU-100HD system.
If more than one JPD-100 Controller is required, a Central Control Unit must be
installed. One controller can be plugged into the front panel controller connector;
the remaining controllers must be connected to the rear panel of the CCU. The
CCU-100 and CCU-100HD units have three channels (1, 2, and 3) on the rear
panel for controllers. The CCU-100A has two channels (1 and 2) on the rear
panel for controllers.
A DIA-01 must be installed between the JPD-100
Controller and the rear panel input ports of the CCUs. The CCU rear panel
controller inputs do not provide the +5Vdc required to operate the JPD-100
circuitry.
SSI-100 SMALL SYSTEM INTERFACE
If the JPD-100 Controller is used with a SSI-100, the coiled cable with the
controller is plugged directly into the front panel Controller Connector of the SSI-
100. The SSI-100 front panel controller connector provides the +5Vdc required
to operate the JPD-100.
CAT VIDEO SWITCHER
The JPD-100 Controller can be connected to the front panel controller connector
or the rear panel COMM input port on the CATS Video Switcher. The front panel
connector on the switcher provides the +5Vdc required to operate the controller’s