Ultrak JPD-100, User Manual

Page: 60 / 124

RUN/STOP VECTORSCAN
518007-1960-G 2-39 KEMU040018
January 2002
PreShot Title
CAM 001 A
MONITOR DISPLAY
(60 Hz System)
The SmartScan unit goes to the next PreShot in the list and remains there for
the specified dwell time. The title of that PreShot is displayed on the monitor.
The SmartScan unit continues to go to the next PreShot and outputs the
PreShot title until it reaches the end of the listing; then it starts over again
with the first PreShot in the listing.
2.2.8.5 Stop VectorScan
The VectorScan continues to run until stopped by an operator. To stop a
VectorScan, the SmartScan unit running the VectorScan must be the
control camera displayed on the controller. Move the large joystick in
any direction or use the OPT>1 command to stop the VectorScan. The
operator now has manual control of the SmartScan unit. If the camera
ID display is enabled on the SmartScan unit, the letter M is displayed on
the monitor next to the camera number when the unit is under manual
control.