Ultrak JPD-100, User Manual

Page: 9 / 124

518007-1960-G KEMU040018
January 2002
TERMS
The following terms are used often throughout this manual. Please become
familiar with them before operating and programming a SmartScan system.
Refer to the specific SmartScan, SmartScan Pro, SmartScan Pro II, or
SmartScan III Operation and Programming Manual for SmartScan programming
procedures. The term SmartScan is used generically for all models unless a
term applies to a specific model. Refer to the SSI-100 Small System Interface
Unit User’s Manual or CCU-100 Central Control Unit User’s Manual for
programming MultiCalls.
PreShot
A PreShot is a camera/lens position including, pan, tilt, zoom, and focus that can
be given a title and stored in a SmartScan unit. Up to 100 PreShots can be
programmed and stored in each SmartScan unit. PreShots are programmed
using a KBD-100 Programming Keyboard and a JPD-100Controller. “Quick”
PreShots can be programmed using the JPD-100 Controller alone. See Section
2 of this manual for programming “Quick” PreShots.
An operator can send a SmartScan unit to a programmed PreShot using the
JPD-100 Controller. When the SmartScan unit is sent to a PreShot, the title of
the PreShot is added to the video signal.
VectorScan
A VectorScan can be considered a video tour. It is two or more PreShots (from
the same SmartScan unit) linked together with dwell times between each
PreShot. Up to ten VectorScans can be programmed and stored in each
SmartScan unit. VectorScans are programmed using the JPD-100 Controller
and/or the KBD-100A Keyboard.
They can be started/stopped at the Controller. When a VectorScan is running in
a SmartScan unit, the title of the PreShot currently being viewed is added to the
SmartScan video signal.