Ultrak JPD-100, User Manual

Page: 75 / 124

AUXILIARY CONTROL
518007-1960-G 2-54 KEMU040018
January 2001
2.2.13 Auxiliary Contact Output Control (ON/OFF).
The controller can be used to turn auxiliary devices on or off. The CAT Video
Switcher, the CRX-800 Series Control Receivers, the CRX-500 Series
Control Receivers, and the AIF-100/CO Contact Output Units all have
contact outputs for connection to VCR's, flood lights, etc. The CRX-800 and
CRX-500 Receivers and the AIF-100/CO units are addressable. The
contacts in these units are controlled by sending an ON message for a
specific contact to the unit address or an OFF message for a specific contact
to the unit address. The contacts in the CAT Video Switcher are controlled
by sending an ON or OFF message for a specific contact to camera address
one. Note: Camera 1 cannot have a CRX-800 or CRX-500 Receiver or an
AIF-100/CO Contact Output Device if a CAT Video Switcher is installed in the
system and the system requires control of the CATS Video Switcher contact
outputs.
If the contact output is configured as normally open, an ON message closes
the contact and an OFF message opens the contact. If the contact output is
configured as normally closed, an ON message opens the contact and an
OFF message closes the contact.
ON COMMAND SEQUENCE
Call up the contact output device address as the primary control camera on
the JPD-100. Perform the following command sequence.
Auxiliary #>AUX>1 # AUX 1
When the JPD-100 is connected to a CCU-100 or a CCU-100A and the
control camera is one (1), an ON message is sent out channel 6 to the CAT