P/N CWSI-IM-C3K6 Rev. F
© 2017 Johnson Controls. All rights reserved. All specifications and other information shown were current as of document revision
date and are subject to change without notice.
72
connected to the N.C. and C terminals of the trouble relay output of the SDACT(-2). There is no polarity
to this connection. This will allow any dialer trouble to be displayed on the CP-3600(+).
Figure 9
7.2.3 Programming
The programming instructions in this manual are intended to make the interface between the CP-
3600(+) and Keltron SDACT(-2) UL 864 compliant. You must program the SDACT(-2) with the
telephone number, account info etc. in order to report to the central station properly. Refer to the
SDACT(-2) manual for further information. Once the wiring and programming of the CP-3600(+) and
SDACT(-2) are complete, any alarms, supervisory or trouble conditions with either the CP-3600(+) or
the SDACT(-2) will be communicated off premises to a central station receiver. Only one programming
change will be required to allow the CP-3600(+) to be compatible with the SDACT(-2). Access the Dialer
Setup menu under the CP-3600(+) Setup screen. Turn the Keltron Dialer Enabled option to on and
save the setting. This will allow the CP-3600(+) to communicate through TB5 and activate monitoring
of the trouble input terminals. There are no software programming or jumper changes to make on the
Keltron SDACT(-2) for use in a fire alarm only installation. Use the default Event Codes and jumper
settings. If the CP-3600(+) is in an installation where Alarm level C is programmed for sprinkler
supervisory then use the Keltron SDACT(-2) software to change zone 3 Alarm Event to FS and the
Alarm Event Restore for zone 3 to FV.
7.2.4 Operation
The SDACT(-2) uses SIA codes to report to the central station. The CP-3600(+) will send the device
Point I.D. and applicable SIA codes to the SDACT(-2) serial port input. This information will also be
communicated to the central statjion by the SDACT(-2) as supplemental information. Table 4 shows
the CP-3600(+) events and the corresponding SIA codes that will be communicated.