P/N CWSI-IM-C3K6 Rev. F
© 2017 Johnson Controls. All rights reserved. All specifications and other information shown were current as of document revision
date and are subject to change without notice.
10
2.2 Compatibility
The following UL Listed RF devices are compatible with the CP-3600(+) Control Panel:
CWSI Models:
A/C Repeater Model AR-5 Rev. 3.0, 3.1 – A/C powered repeater
WRA-3(R)(LG) – Remote Annunciator
SR-5 – Wireless Relay receiver
520(R)(W) Rev. 1.5 – Low Frequency Sounder (audible notification device) Compatible only with
Model AR-5 Rev. 3.1 repeater
MH(R)(W) Rev. 1.5 – Mini Horn Sounder (audible notification device) Compatible only with Model AR-
5 Rev. 3.1 repeater
Smoke Detector Model 300 – Photo Electric Smoke Detector with Integral Sounder
Smoke Detector Model 301 – Tandem Photo Electric Smoke Detector with Integral Sounder
Smoke Detector Model 302 – Photo Electric Smoke Detector without Sounder
Heat Detector Model 320 – 135° Heat Detector
Smoke Heat Detector Model 325 – Combination Smoke Heat Detector
Pull Station Model 310 – Manual Pull Station
Fire Transmitter Models 345(TS) – N.O. EOL Supervised Transmitter
CO Detector Model 350 – Carbon Monoxide Detector with Integral Sounder
The following antennas are for use with the CP-3600(+):
CWSI Models:
OM-1 Omni – Isotropic gain 2.5 dBi, OM-2 Omni – Isotropic gain 1 dBi, OM-3 Omni – Isotropic gain 5
dBi, YA-1 Yagi – Gain 15.2 dBi
The following UL Listed Digital communicators are compatible with the CP-3600(+) Control
Panel:
Silent Knight 5104B
Keltron SDACT, SDACT-2
The following accessories are for use with the CP-3600(+):
CWSI-BPF-915 Optional Band Pass Filter for Antenna SMA Connector
Notification Appliances:
As listed in the Notification Appliance Compatibility section of this manual.
Manual Service
Mount the pull station on a UL listed non-metallic junction box. Use a separate UL listed non-metallic
junction box with minimum inside dimensions of (HxWxD) 5” x 3” x 2” to house the model 345(TS)
transmitter. The two junction boxes shall be closed nippled together using a non-metallic conduit nipple.
Wire the transmitter to the pull station N.O. contacts. Refer to the 345(TS) manuals for wiring
instructions.