Triumph Adler CLP 4550, Instruction Handbook Manual

Page: 191 / 236

Troubleshooting 6-7
You attempted to print with a paper size and paper type that cannot be used for
duplex printing. Press
[OK] to print onto one-side of the paper only.
Turn off the printer then turn it back on to see if the printer has recovered. If the
printer has not recovered, turn off the printer, disconnect the power cord, and
contact your service representative or authorized service center.
The printer controller and operation panel cannot exchange data. Turn off the
printer then turn it back on to see if the printer has recovered. If the printer has not
recovered, turn off the printer, disconnect the power cord, and contact your
service representative or authorized service center.
This message is displayed when the Job Accounting function is enabled and an
attempt has been made to exceed the print limit set for each account. To return
the printer to the print-ready status, press
[OK] .
For more information, refer to Job Accounting (Job Accounting settings) on page
4-95 .
Printing using the Job Box function failed because there was insufficient space
available on the hard disk. To print an error report and return the printer to the
print-ready status, press
[OK] .
This message is displayed when printing was attempted, despite the Job Account
function being on with Restriction applied as the job limit for each job account.
To return the printer to the print-ready status, press
[OK] .
For more information, refer to Job Accounting (Job Accounting settings) on page
4-95 .
Message Corrective Action
Cannot duplex print
on this paper.
Error occurred.
Turn the main power
switch off and on.
F###
Error occurred.
Turn the main power
switch off and on.
F000
Job Accounting
restriction exceeded.
Press [OK].
Job not stored.
Press [OK].
Restricted by
Job Accounting.
Press [OK].