10-2
•
Make sure all data is uploaded and deleted from the receiving
TriCoder. The TriCoder will not allow you to receive data unless
the TriCoders data files are empty.
•
Plug in the 5-volt power adapter(s). You want to make sure you
don’t have a low-battery situation in the middle of a transfer.
•
For serial and keyboard cloning, always start the receiving
TriCoder first. For USB cloning to a host computer, follow the
instructions on the TriCoder’s display.
•
When transmitting between two TriCoders, both TriCoders must
be configured to use the same Computer Interface. If configured
as serial interface, the serial parameters must be the same on both
TriCoders; baud rate, parity, data bits and stop bits must match.
Two USB TriCoders cannot be cloned together.
Cloning to or from older TriCoders
If you are cloning to or from an older TriCoder that only has 64K or 256K
with memory partitions, you may get a message telling you:
Partitions Not Cloned
Press Any Key
Press a key, then when your cloning is finished, go in and manually set up
the partitions in your cloned TriCoder.
Receiving a program on the TriCoder from another
TriCoder
Make sure all cables are attached correctly and the 5-volt power adapter is
plugged in. To start the receiving TriCoder, answer NO to all prompts until
you see:
PROGRAM RECEIVE?
KEY [YES/NO]?_
Press YES to get to the RECEIVE PROGRAM menu:
RECEIVE PROGRAM KEY
------------------------------ -------
Programs [1-3]?---------->1 - 3
Clone TriCoder------------> 0_
Press 0 to Clone the entire TriCoder. Cloning receives the programs, tables,
Setup, and voice messages (if using a voice cloning cable T15) from
another TriCoder. If cloning from a host computer, only the programs,
tables and Setup can be received.
Press 1, 2 or 3 to receive a program only. Pressing 1, 2 or 3 determines
which program number you are assigning - it does not have to correspond
