8-24
Finishing and checking your program
When you have finished entering your program, press the F1 key to have
the TriCoder check your program for errors. If you have referenced a
statement number that doesn’t exist or hasn’t been defined properly, you
will see the message:
INVALID STMT. #
HIT ANY KEY_
Pressing a key will take you to the statement number where the TriCoder
found the problem. Make the appropriate corrections then press the F1 key
again. If the TriCoder finds no other
problems
, you will see the
Programming menu prompt:
Create Programs->
1
-3
Voice
-> 4 Setup -> 5
Automation ---
----->
7
Data File Names-->
6
(hidden)
You can now create another program by pressing 1-3, or exit
PROGRAMMING MODE entirely by pressing the F1 key to return to the
Mode Menu.
If you don’t press the F1 key when you are finished creating your program
and the TriCoder shuts off (goes to sleep in the middle of programming –
maybe you were interrupted and left to do something else), when you turn
the TriCoder back on, you may get the following message:
INCOMPLETE PROGRAM
HIT ANY KEY_
Press a key to get to this prompt:
PROGRAMMING MODE
PASSWORD?_
Enter the password (WDTRI), then choose the number of the program you
were working on when you see the PROGRAM FUNCTION menu:
Create Programs->1-3
Voice
-> 4 Setup -> 5
Automation ----
---->
7
Data File Names-->6
(hidden)
Press the number of the program you were working on. Answer YES to
EDIT PROGRAM?. Once inside the program, press the F1 key to locate
the problem. If the program doesn’t resemble what you were working on
before, it is possible you have had some kind of memory problem. See
