6-3
help you navigate the menu:
Up Arrow
moves to beginning of category
Down Arrow
moves to end of category
Left Arrow
moves up one in the category
Right Arrow
moves down one in the category
Press the F1 key to go back to the category selection screen.
Using the TriCoder Utilities and USB to change
Setup Parameters
If you are using the High Speed USB interface, you can use the TriCoder
Utilities program to change your setup parameters.
To use the TriCoder Utilities, you must make sure your TriCoder is turned
on, plugged into the USB cable and is set for High Speed USB interface. In
the TriCoder Utilities program, choose Tools from the pull-down menu, and
then choose TriCoder Setup.
Click on any of the tabs to change settings for that section. Once you have
made your changes, click OK and the changes are automatically made in
your TriCoder.
Cloning from one TriCoder to another
If your programs, tables and setup are complex or large, transmitting them
from TriCoder to TriCoder is faster and easier than manually entering all of
the information every time. Transmitting programs and setup to a host
