TransTel Communications G1E Plus, User Manual

Page: 21 / 144

05-02-04 100 200 300 400 600 800 1000 1200 1400 1600 ms.
05. PSTN Line Flash Time - Key Phone & Analog Phone
This parameter sets the Flash timer at PSTN trunk line when Key Phones pressing the [TRF/FL] key or an analog
phone makes a flash and then dials 800 while accessing an outside line. After dialing 800 the flash signal will be sent
to the PSTN line and the analog phone will be reconnected to the PSTN line again.
IP \ Value 0 1 2 3 4 5 6 7 8 9 Unit
05-02-05 40 80 160 240 400 600 800 1000 1200 1400 ms.
UK, Italy, Aust 60 80 100 120 140 160 180 200 300 600 ms.
06. SLT Hold Signal Time
This parameter permits the selection of the Flash time from a single line telephone that the system will recognize as a
Hold signal if the time is greater than this hold signal time but less than the SLT release time (Program 05-02-04)
IP \ Value 0 1 2 3 4 5 6 7 8 9 Unit
05-02-06 70 80 100 200 300 400 500 600 700 800 ms.
07. Ring On Time
This parameter allows the system to identify a minimum ring signal time from the PSTN line. This parameter should
never be changed without a clear understanding of the operation of the feature.
IP \ Value 0 1 2 3 4 5 6 7 8 9 Unit
05-02-07 0 160 240 360 440 560 640 760 840 960 ms.
08. Ring Off Time
This parameter allows the system to identify when a ringing call has abandoned by the absence of any ring signal from
the PSTN. This parameter should never be changed without a clear understanding of the operation of the feature.
IP \ Value 0 1 2 3 4 5 6 7 8 9 Unit
05-02-08 2 2 2 3 4 5 6 7 8 9 Sec.