TRADEDX SSR-4N108L, User Manual

Page: 74 / 85

List All Sensors and Status Using Linux
1. Log into the Linux terminal.
2. Open the terminal. Execute the ipmitool command to display all supported sensors as
shown in the following figure.
Command:
#ipmitool –H <ip address> -U <username> -P <password> -I lanplus sensor
Storage Drive LEDs
The system LED is used to show the state of the enclosure. The following table lists
storage LED indicators in the system.
Module LED Indicator
LED
color
LED condition Description
SAS Wide-
Port
SAS Link LED Green
ON SAS Link Up
OFF SAS Link Down
SAS Status LED Amber
ON Data Transmission
OFF
No Data
Transmission
Online/ Present
LED
Blue
ON HDD is present
OFF HDD is not Present
HDD Locate/ Fault Red
ON Failed
OFF Normal
Blinking (4Hz) Identifier
Blinking (long-short-
short)
HDD slot power is
off
Updating Expander Board Firmware
Updating expander firmware can fix related problems with the storage system. The
expander firmware can be updated through a host based utility
– g3Xflash.