Installing a Chassis on the Rack
CAUTION:
This procedure requires at least two operators to hold and install the chassis.
Follow these steps to install a chassis on the rack:
1.
Before you begin, make sure the rails are rails are properly installed on the
chassis and the rack. See
“Installing the Rackmount Rails” on page 67.
2.
Align the chassis with the rack. Make sure the chassis is positioned correctly and
the rear side of the chassis is facing the back of the rack cabinet.
3.
If we are not installing HDDs:
4.
Slide the chassis into the rack until it is flush with the rack posts.
5.
Secure the chassis in the rack with screws.
6.
If we are installing HDDs:
7.
Slide the chassis halfway into the rack, making sure the rear top cover is accessible.
8.
Install the expander boards. See
“Installing an Expander Board” on page 33.
9.
Install the HDDs. See
“Installing a 3.5” HDD” on page 28.
10.
Slide the chassis into the rack cabinet until the chassis is flush in the cabinet.
11.
Secure the chassis in the rack with screws.
Summary of Contents for SSR-4N108L
Page 1: ...JBOD SSR 4N108L User Manual ...
Page 16: ...System Architecture ...
Page 61: ...Signal Cable Routing ...
