Installing Rear Panel Board
Follow these steps to install a RPB:
1.
Align the I/O ports on a RPB with the slots on the chassis.
2.
Slide a RPB into position. Make sure the I/O ports are seated correctly.
3.
Lower a RPB onto the chassis. Make sure the screw holes on a RPB and chassis are
aligned.
4.
Secure a RPB to the chassis with screws.
5.
Connect the cables to a RPB.
6.
Install a rear top cover. See
“Installing a Rear Top Cover” on page 25.
7.
Close an HDD drawer. See
“Closing an HDD Drawer” on page 14.
Fan Board
Removing a Fan Board
Follow these steps to remove a fan board:
1.
Power off the JBOD and detach all of the power cords from the power supply.
2.
Open an HDD drawer. See
“Opening an HDD Drawer” on page 13.
3.
Remove a rear top cover. See
“Removing a Rear Top Cover” on page 24.
4.
Disconnect the cables from a fan board.
5.
Remove the screws securing a fan board to the chassis.
6.
Slide a fan board to unlock from the chassis standoffs and remove.
Summary of Contents for SSR-4N108L
Page 1: ...JBOD SSR 4N108L User Manual ...
Page 16: ...System Architecture ...
Page 61: ...Signal Cable Routing ...
