TRADEDX SSR-4N108L, User Manual

Page: 19 / 85

b.
Set JBOD topology mode as “0x04: Shared”.
Get JBOD Topology Configuration
Before starting this procedure, make sure the JBOD is powered on.
1. Log into the Linux.
2. Open the terminal.
3. Execute the ipmitool command to get Topology mode from installed expanders (1~4).
Command:
#ipmitool –H <ip address> -U <username> -P <password> -I lanplus raw 0x30 0x03
<Expander ID>
Hint:
<Expander ID> : ID of specified expander, must be 1 ~ 4.
Example:
a.
JBOD topology mode is “0x01: Standard” currently.
#ipmitool –H 192.168.0.100 -U admin -P admin -I lanplus raw 0x30 0x03 0x01
01 a0 01
#ipmitool
–H 192.168.0.100 -U admin -P admin -I lanplus raw 0x30 0x03 0x02
02 a0 01
#ipmitool –H 192.168.0.100 -U admin -P admin -I lanplus raw 0x30 0x03 0x03
03 a0 01
#ipmitool –H 192.168.0.100 -U admin -P admin -I lanplus raw 0x30 0x03 0x04
04 a0 01
#ipmitool –H 192.168.0.100 -U admin -P admin -I lanplus raw 0x30 0x04 0x01 0xa0
0x04
01
#ipmitool –H 192.168.0.100 -U admin -P admin -I lanplus raw 0x30 0x04 0x02 0xa0
0x04
02
#ipmitool –H 192.168.0.100 -U admin -P admin -I lanplus raw 0x30 0x04 0x03 0xa0
0x04
03
#ipmitool –H 192.168.0.100 -U admin -P admin -I lanplus raw 0x30 0x04 0x04 0xa0
0x04
04
#ipmitool –H 192.168.0.100 -U admin -P admin -I lanplus raw 0x30 0x02 0x01 0x00
01
#ipmitool –H 192.168.0.100 -U admin -P admin -I lanplus raw 0x30 0x02 0x02 0x00
02
#ipmitool –H 192.168.0.100 -U admin -P admin -I lanplus raw 0x30 0x02 0x03 0x00
03
#ipmitool –H 192.168.0.100 -U admin -P admin -I lanplus raw 0x30 0x02 0x04 0x00
04