Rackmount Installation
Removing a Chssis from the Rack
CAUTION:
This procedure requires at least two operators to hold and install the chassis.
Follow these steps to remove a chassis from the rack:
1.
Power off the JBOD and detach all of the power cords from the power supply.
2.
Open an HDD drawer. See
“Opening an HDD Drawer” on page 13.
3.
Remove the HDDs. See
“Removing a 3.5” HDD” on page 30.
4.
Remove the expander boards. See
“Removing an Expander Board” on page 31.
5.
Disconnect the cabling from the rear side of the chassis.
6.
Remove the screws securing the chassis and the rack.
7.
Hold the hand rails and pull the chassis out of the rack. Make sure to
completely support the chassis while removing to avoid injury or damaging
the equipment.
Summary of Contents for SSR-4N108L
Page 1: ...JBOD SSR 4N108L User Manual ...
Page 16: ...System Architecture ...
Page 61: ...Signal Cable Routing ...
