Inner Rail
Removing an Inner Rail
Follow these steps to remove an inner rail:
1.
Power off the JBOD and detach all of the power cords from the power supply.
2.
Open an HDD drawer. See
“Opening an HDD Drawer” on page 13.
3.
Remove the HDDs. See
“Removing a 3.5” HDD” on page 30.
4.
Remove the expander boards. See
“Removing an Expander Board” on page 31.
5.
Disconnect the cables from the HDD backplanes.
6.
Remove an HDD drawer. See
“Removing an HDD Drawer” on page 15.
7.
Place an HDD drawer on a clean work space.
8.
Remove the screws securing an inner rail to the HDD drawer.
9.
Pull the latch upward and remove the keyhole from standoff.
10.
Slide an inner rail forward to release and remove an inner rail.
11.
Repeat the previous procedures for the additional inner rail.
Summary of Contents for SSR-4N108L
Page 1: ...JBOD SSR 4N108L User Manual ...
Page 16: ...System Architecture ...
Page 61: ...Signal Cable Routing ...
