4.
Connect the cables to a PDB.
5.
Install a PDB cover. See
“Installing a Power Distribution Board Cover
(PDB Cover)” on page 44.
6.
Install a rear top cover. See
“Installing a Rear Top Cover” on page 25.
7.
Close an HDD drawer. See
“Closing an HDD Drawer” on page 14.
Chassis Management Module (CMM)
Removing a Chassis Management Module
Follow these steps to remove a CMM:
1.
Open an HDD drawer. See
“Opening an HDD Drawer” on page 13.
2.
Loosen a thumb screw securing a CMM to the HDD drawer.
3.
Disconnect a CMM from the HDD backplane.
Installing a Chassis Management Module
Follow these steps to install a CMM:
1.
Align the connector on CMM with the connector on HDD backplane.
2.
Install a CMM. Press down gently to seat in place.
3.
Secure a CMM with a thumb screw.
4.
Close an HDD drawer. See
“Closing an HDD Drawer” on page 14.
Summary of Contents for SSR-4N108L
Page 1: ...JBOD SSR 4N108L User Manual ...
Page 16: ...System Architecture ...
Page 61: ...Signal Cable Routing ...
