User Guide
719
Configuring DoS Defend
DoS Defend Configuration
2
DoS Defend Configuration
2.1 Using the GUI
Choose the menu
SECURITY > DoS Defend
to load the following page.
Figure 2-1
DoS Defend
Follow these steps to configure DoS Defend:
1) In the
DoS Defend
section, enable DoS Protection and click
Apply
.
2) In the
DoS Defend Config
section, select one or more defend types according to your
needs and click
Apply
. The following table introduces each type of DoS attack.
Land Attack
The attacker sends a specific fake SYN (synchronous) packet to the destination
host. Because both of the source IP address and the destination IP address of
the SYN packet are set to be the IP address of the host, the host will be trapped
in an endless circle of building the initial connection.
Scan SYNFIN
The attacker sends the packet with its SYN field and the FIN field set to 1. The
SYN field is used to request initial connection whereas the FIN field is used to
request disconnection. Therefore, the packet of this type is illegal.
Xmascan
The attacker sends the illegal packet with its TCP index, FIN, URG and PSH field
set to 1.
Downloaded from
