Configuring ACL
ACL Configuration
User Guide
589
Figure 2-4
Configuring the MAC ACL Rule
Follow these steps to configure the MAC ACL rule:
1) In the
MAC ACL Rule
section, configure the following parameters:
Rule ID
Enter an ID number to identify the rule.
It should not be the same as any current rule ID in the same ACL. If you
select Auto Assign, the rule ID will be assigned automatically and the interval
between rule IDs is 5.
Operation
Select an action to be taken when a packet matches the rule.
Permit
: To forward the matched packets.
Deny
: To discard the matched packets.
S-MAC/Mask
Enter the source MAC address with a mask. A value of 1 in the mask indicates
that the corresponding bit in the address will be matched.
D-MAC/Mask
Enter the destination MAC address with a mask. A value of 1 in the mask
indicates that the corresponding bit in the address will be matched.
VLAN ID
Enter the ID number of the VLAN to which the ACL will apply.
Downloaded from
