Toshiba TOSVERT VF-MB1, Instruction Manual

Page: 259 / 350

E6581697
G-11
7

List of output terminal function settings
List of detection levels for output terminal selection
Parameter
programmed value
Parameter
programmed value
Positive
logic
Negative
logic
Function
Positive
logic
Negative
logic
Function
   
Frequency lower limit
 
Light load output
   
Frequency upper limit
 
Heavy load output
   
Low-speed detection signal
 
Lower limit frequency stop
   
Output frequency attainment signal
(acceleration/deceleration completed)
 
Power failure synchronized operation
   
Set frequency attainment signal
 
Traverse in progress
   
Fault signal (trip output)
 
Traverse deceleration in progress
   
Over-current pre-alarm
 
Parts replacement alarm
   
Overload pre-alarm
 
Over-torque detection pre-alarm
    Overheat pre-alarm   Frequency setting mode selection 1/2
    Overvoltage pre-alarm   Panel / remote selection
   
Power circuit undervoltage detection
 
Forced continuous operation in progress
   
Small current detection
 
Specified frequency operation in progress
   
Over-torque detection
 
Signal in accordance of frequency
command
    Braking resistor overload pre-alarm   Fault signal (output also at a retry
waiting)
    Run/Stop   PTC input alarm signal
    Heavy fault   Safe torque off signal
    Light fault   Analog input break detection alarm
    Cooling fan ON/OFF   F terminal state
    In jogging operation   R terminal status
    Operation panel / terminal board
operation   Cooling fan replacement alarm
    Cumulative operation time alarm   Number of starting alarm
    Communication option
communication error   Acceleration operation in progress
    Forward/reverse run   Deceleration operation in progress
   
Ready for operation 1
 
Constant speed operation in progress
    Ready for operation 2   DC braking in progress
    Brake release  to  Factory specific coefficient *1
    Pre-alarm  to  Logic sequence function output 1 to 16
    RS485 communication error  Always OFF
    Designated data output 1  Always ON
   
Designated data output 2

*1: Factory specific coefficients are manufacturer setting menus. Do not change the value of these parameters.
<Explanation of terminology>
 Alarm …... Alarm output when a setting has been exceeded.

Pre-alarm …... Alarm output when the inverter may cause a trip during continued operation.