Toshiba e-Studio477s, Service Manual, Page: 310 / 482

e-STUDIO477S/527S/477SL © 2013-2016 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
8 - 22
• If the state of "FROM Licence Status" is "KeyMismatch", restore the license data by pressing
the [3] key to select "3. License SRAM to FROM ", then press the [START] button.
• If ADI-HDD is installed, restore the encryption key data by pressing the [5] key to select "5.
ADIKey SRAM to FROM", then press the [START] button.
(15) Press the [ON/OFF] button to shut down the equipment.
(16) Initialize the updated data by following the steps below.
• Turn the power ON by pressing the [ON/OFF] button while holding down the [0] and [8] keys
simultaneously.
• Key in “9030”, and then press the [START] button.
• Press the [INITIALIZE] button.
[B] Confirmation of the updated data
After the updating is completed, check each data version in the Setting Mode (08) to confirm that the
data was overwritten properly.
 P. 8-26 "8.5 Confirmation of the updated data"