Toshiba e-Studio477s, Service Manual, Page: 333 / 482

10
© 2013-2016 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO477S/527S/477SL
EXTERNAL COUNTERS
10 - 1
10. EXTERNAL COUNTERS
10.1 Outline
This chapter describes the interface between the equipment and coin controller. This equipment does
not support card controller and mechanical counter.
10.2 Signal
Notes:
•
Use 24V supplied from the main equipment as power for the output signals (KCTRON) from the
transistor.
• Do not connect inductive loads, such as a mechanical counter or a relay coil, to CTRON.
10.2.1 Pin Layout
1. Connector on the PU board: COIN (JST-made B20B-CZHK-B-1(LF)(SN)(V)) (Coin Controller)
Pin
No.
I/O Signal name Function Voltage level Remarks
GQ-
1260
1 GND SG Signal Ground 0V -
2 In CTRCNT Copy permission
Signal 1 L=0V, H=DC3.3V -
3 Power +24V 24V line DC24V+10%, -5% -
4 Out
KCTRON Mechanical
Counter On Signal Open Collector L: ON
-
5 Power +24V 24V line DC24V+10%, -5% -
6 Out CTRON Total Counter On
Signal Open Collector L: ON In use
7 In
CTRCNT Copy permission
Signal 1 L=0V, H=DC3.3V L: Allowed
In use
8 Out
MCRUN Ready to Copy
Signal Open Collector L: Operating
In use
9 Out EXTCTR Exit Sensor On
Signal Open Collector L: Operating In use
10 GND PG Power ground 0V In use
11 Out BKCTR Black mode
Counter Signal Open Collector L: Operating -
12 Out
MNCTR Mono color mode
Counter Signal Open Collector L: Operating
-
13 Out FLCTR Full color mode
Counter On Signal Open Collector L: Operating -
14 GND SG Signal Ground 0V -
15 Out SIZE3 Paper size Signal
3 Open Collector L: Operating -
16 Out
SIZE2 Paper size Signal
2 Open Collector L: Operating
-
17 Out SIZE1 Paper size Signal
1 Open Collector L: Operating -
18 Out SIZE0 Paper size Signal
0 Open Collector L: Operating -
19 Power
+5V (Sleep) 5V line DC5.1V At the sleep mode:OFF
In use
20 -
N.C. - -
-