Toshiba e-STUDIO350, Service Manual, Page: 129 / 286

November 2003 © TOSHIBA TEC 6 - 21 e-STUDIO350/450 SCANNER
6
[J] Carriage wire / Carriage-2
(1) Take off the carriage-1 ( Chapter 6.7 [G]).
(2) Install the wire holder jig to each pulley on front
and rear sides, not to loosen the carriage wire.
Note:
Refer to “3.9 Adjustment of Carriages” in the
Service Handbook for the installation direc-
tion of the wire holder jig.
(3) Remove the tension springs on both front and
rear sides.
(4) Remove the carriage wires on both front and
rear sides.
(5) Rotate the carriage-2 in the direction where
the inside of the frame is dented shown in the
figure at right, not to touch the mirror. Then
take off the carriage-2.
Fig. 6-719
Fig. 6-720
Fig. 6-721
Tension spring
[K] Mirrors-2 and -3
(1) Take off the carriage-2 ( Chapter 6.7 [J]).
Note:
When replacing the mirrors-2 and -3, re-
place the carriage-2 together with mirrors-
2 and -3.
Mirrors-2 and -3 should not be removed.