Toshiba e-STUDIO350, Service Manual, Page: 127 / 286

November 2003 © TOSHIBA TEC 6 - 19 e-STUDIO350/450 SCANNER
6
[F] Scan motor
(1) Take off the rear cover and upper rear cover
( Chapter 2.5.1 [C][G]).
(2) Disconnect the connector of the scan motor
and remove 1 spring.
(3) Remove 3 screws and take off the scan motor.
Note:
When installing, use a stepped screw to fix
the left rear point.
[G] Carriage-1
(1) Take off the original glass ( Chapter 6.7 [A]).
(2) Take off the upper rear cover and front upper
cover ( Chapter 2.5.1 [G][E]).
(3) Move the carriage-1 to the position shown in
the figure at right, and match the positions of
each hole and screw.
(4) Remove 2 screws. Then pull down each
bracket fixing the wire from the hole of the
frame on both ends of carriage-1.
(5) Disconnect 1 connector from the SLG board.
Remove 2 seals and release the cable.
Fig. 6-712
Fig. 6-713
Fig. 6-714
Fig. 6-715
Rear side
Stepped screw