Toro 00075SL, Service Manual

Page: 129 / 290

Hydraulic
System
Rev. D
Reelmaster 5500-D Hydraulic System (Rev. C) Page 4 - 91
Removal
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
Note: The electrical harness dose not have to be dis-
connected to remove the right fender and control con-
sole from the frame.
2. Remove right fender with control console attached
enough to allow removal of the hydraulic reservoir.
3. Drain reservoir into a suitable container (see Change
Hydraulic Fluid).
4. Remove oil tank (Fig. 101).
Hydraulic Reservoir Inspection
1. Clean hydraulic reservoir and suction strainer with
solvent.
2. Inspect hydraulic reservoir for leaks, cracks, or other
damage.
Hydraulic Reservoir Installation
1. Install reservoir (Fig. 101).
Note: When applying Permabond LH150 or equiva-
lent to the threads of the suction strainer, do not apply
sealant to the first thread.
2. Apply Permabond LH150 or equivalent to the
threads of the suction strainer.
3. Using a wrench, turn strainer into port at least 1-1/2
to 2 full turns beyond finger tight, or until fully seated.
4. Apply an anti-seize compound to three cap screws
that secure the reservoir to the frame. Install and torque
screws 30 to 60 in−lb (3.4 to 6.8 N−m).
5. Fill reservoir with hydraulic fluid (see Change Hy-
draulic Fluid).