ThermoFisher Scientific Vanquish VH-D10, Operating Manual

Page: 47 / 196

5 • Installation
Vanquish Diode Array Detectors (VH-D10) Operating Manual Page 47
5.2 Installing the Detector
The Vanquish system is installed and set up by a Thermo Fisher Scientific
service engineer, including all modules and options or parts shipped with
them. The service engineer checks that the installation is correct and
that the Vanquish system and modules operate as specified. The
engineer also demonstrates the basic operation and main features.
If personnel other than a Thermo Fisher Scientific service engineer
installs the detector, follow the steps below.
NOTICE The detector is part of the Vanquish system. Therefore, follow
the order for installing the system modules as described in the
Vanquish
System Operating Manual
.
1. Pay attention to the safety guidelines and observe all site
requirements.
For the safety guidelines when installing the detector, see
section 5.1, page 46 . For the site requirements, see section 5.3,
page 49 .
2. Set up the detector hardware. See section 5.5, page 52 .
3. Set up the flow connections. See section 5.6, page 62 .
4. Turn on the detector. See section 5.8, page 78 .
TIP Before turning on the power to a Vanquish system module for the
first time, verify that the chromatography software is installed on the
data system computer. When the power is turned on, the required USB
drivers are automatically found and the Windows™ operating system
can detect the device.
5. Set up the detector in the software. See section 5.9, page 79 .