ThermoFisher Scientific Vanquish VH-D10, Operating Manual

Page: 41 / 196

4 • Unpacking
Vanquish Diode Array Detectors (VH-D10) Operating Manual Page 41
3. Remove the detector from the shipping container: Grasp the
detector by the carrying handles. Slowly and carefully, lift the
detector out of the shipping container.
Figure 5: Carrying handles on the detector
No. Component
1 Carrying handles
2 Attachment screw (one on each carrying handle)
4. Place the detector on a stable surface.
5.
If applicable
Remove any additional packing material. Leave any protective films
attached to the surfaces of the detector until it is properly
positioned in the system stack.
6. Transport the detector by the carrying handles to the installation
site, if it is not already there, and place it in the system stack (see
the
System Arrangement
section in this operating manual).
7. On each carrying handle, loosen the attachment screw until the
carrying handle is moveable in the rail. Do not remove the screws
from the carrying handles completely.
8. Slide off the carrying handles from the rails towards the rear of the
detector.
Figure 6: Sliding off the carrying handle from the left rail