Thermo Scientific SOLA II, User Manual

Page: 41 / 205

Installation
Electrical Connections
Thermo Fisher Scientific SOLA II User Guide 3-3
1. Thoroughly rinse the tubing inside with isopropyl alcohol (isopropanol) or
acetone to remove any oils that may be present.
2. Flush the inside of the tubing with deionized water.
3. Rinse the inside of the tubing again with isopropyl alcohol (isopropanol)
or acetone.
4. Thoroughly blow-dry the tubing with clean air (free of oil and moisture).
Refer to the following AC power information and wire information when
planning and connecting power for the analyzer.
Power source specification: 110 or 220 Vac, 50/60 Hz, 2000 W
Power wiring specification: Use stranded, 3-wire copper or tin-plated copper
power wire rated for at least 600 Vac and 20 A at the required length.
Warning
This apparatus must be earth grounded!
σ
Warning
Installation of this instrument requires an external, lockable
electrical power isolation switch supplied by the customer.
σ
If the optional X-Purge unit is installed, refer to Appendix G for important
installation and operation information.
Wiring to the relay contacts should be sized according to the load imposed by
the alarm systems installed by the user. Maximum current capability of the
alarm contacts is 2 A at 240 Vac or 10 A at 24 Vdc. Voltage is not supplied to
the relay contacts by the analyzer.
The following inputs and outputs can be connected to a Distributed Control
System (DCS) or other devices as desired.
Electrical
Connections
DCS & External
Connections
Digital Inputs