Thermo Scientific SOLA II, User Manual

Page: 171 / 205

The Workstation
Workstation Operation
Thermo Fisher Scientific SOLA II User Guide F-3
a. Set the IP address to the value assigned to the Bridge. The required IP
address depends on the configuration of the Modbus Ethernet.
Contact the person responsible for this network to obtain the correct
IP address.
b. Set the identifier to 1.
If a serial port is used for the connection, configure the serial port
parameters as follows:
a. Select Lookout Options > Serial Ports.
b. Verify that the port is configured as shown in Figure F–3.
Note
The specified Receive gap, RTS delay, and CTS time-out are critical to
achieve successful communication with the analyzer. Depending on the PC
used, these numbers may need to be increased.
σ
Figure F–3.
Workstation Operation