Dionex ICS-5000
+
Installation Instructions
62
Doc. 065447-02 12/14
3. Determine how you want to route the drain line to the waste container or
drain. Then, lay out parts on the bench to determine which parts will be
required. Observe the following guidelines:
•
Use one of the short pieces of tubing to connect to the DC drain port.
•
Position an elbow fitting at the edge of the bench. The corrugated
drain hose connects to this fitting. For stability, make sure the
horizontal leg of the elbow fitting is supported on the bench.
•
Use the tee fitting in the configuration; it can be placed in any
location. Install the vent plug (with the holes facing up) in the open
port on the tee.
NOTE
If the supplied tubing lengths do not fit your installa-
tion site, you can cut the tubing to create the length
Figure 3-31. Drain Line Routed to Side of Bench
Figure 3-32. Drain Line Routed to Front of Bench
