3 • System Setup
Doc. 065447-02 12/14
63
you need. Make sure to cut the tubing squarely to
ensure a good connection between the tubing and the
fittings.
4. To assemble the rigid drain line:
a.
Push the PTFE tubing into the fittings.
b. Verify that the black o-ring inside the drain port opening on the DC is
fully seated in the groove, and then push the short length of tubing
straight into the drain port.
NOTE
The o-ring inside the drain port ensures a leak-free fit
between the drain line and drain port. If the drain line
is pushed into the port at an angle, it can force the o-
ring out of its groove.
5. Push the corrugated drain hose into the elbow fitting at the edge of the
bench. Place the open end of the line into a waste container or appropriate
drain.
For correct drainage, make sure the entire rigid drain assembly (from
the DC drain port to the edge of the bench) lays flat on the bench.
Make sure the corrugated drain hose is not bent, pinched, or elevated
at any point. Do not allow the end of the drain hose to be submerged in
waste liquid.
