3 • System Setup
Doc. 065447-02 12/14
39
•
When mounted on the top edge, the temperature stabilizer inlet and
outlet are on the left side. When mounted on the bottom edge, the
inlet and outlet are on the right side. Determine which orientation will
allow you to minimize the length of connections to other system
components.
3. Orient the temperature stabilizer as required and press it onto the
standoffs near the top or bottom edge of the thermal element. For
example,
shows a temperature stabilizer installed on the
bottom edge.
4. Repeat
for the second temperature stabilizer, if needed.
5. Reinstall the column brackets in the TC as follows:
a.
Check that the outside edge of the temperature stabilizer is flush with
the edge of the thermal element.
b. While holding the temperature stabilizer in place, attach the brackets
to positions
and
by loosely installing first the screw in the
top
of each bracket and then the screw in the
bottom
of each bracket. Use
the 2.5 mm hex key (P/N 052952) provided in the TC Ship Kit
(P/N 064789) to install the screws.
c.
Repeat the steps above to reinstall the brackets in positions
and
.
d. Tighten all eight screws evenly.
Figure 3-10. TC Temperature Stabilizer Installed
1
2
3
4
1
4
2
3
