Engine Maintenance
99
Draining Water from Fuel Tank
Water run through the system may damage the
injection pump or nozzles. Damage to the fuel
system will subsequently cause more expensive
damage to the engine. A large accumulation of
water in the bottom of the fuel tank will stop a
diesel engine. Water should be drained off during
scheduled maintenance inspections to prevent
breakdowns. Drain the water off after the fuel
tank and unit have remained idle for an hour.
1. Place a container under the fuel tank to catch
the draining water and fuel.
2. Remove the drain plug from the bottom of the
fuel tank.
NOTE: Some fuel tanks have a check valve
in the drain plug fitting. Push the check
valve open with a small screw driver to drain
the tank.
3. Let the water and fuel drain into the container
until no water is visible in the fuel draining
from the tank. If the water and fuel do not
drain freely, the vent may be plugged. If so,
clean or replace the vent.
4. Install the drain plug.
Fuel Filter Replacement
Replace the fuel filter at intervals according to the
Maintenance Inspection Schedule.
1. Remove the filter and discard.
2. Lubricate rubber ring of new filter with fuel.
3. Install the filter and tighten until the filter is
slightly loose (rubber ring not making
contact).
4. Bleed the air from the filter by operating the
electric pump until fuel bubbles appear at the
top of filter.
5. Tighten the filter until the rubber ring makes
contact, then tighten 1/2 turn more.
1.
HEAD - filter
13. HOSE - fuel (3/8 x 35 ft)
2.
SPUD - filter
14. JOINT - fuel
3.
SHAFT - water bleed
15. JOINT - fuel
4.
FILTER - fuel
16. PUMP - fuel injection
5.
HOSE - fuel (1/4 od x 35 ft lg)
17. PUMP - fuel (12V)
6.
ELBOW - hose (1/4)
18. HARNESS - fuel pump
7.
KIT - sleeve & eyelet (1/4)
19. WRENCH - fuel bowl
8.
NUT (1/4)
20. CLAMP - hose (1/4 x 1/4)
9.
ELBOW - hose (3/8)
21. CLAMP - hose (1/4 x 3/8)
10. KIT - sleeve & eyelet (3/8)
22. GROMMET
11. NUT (3/8)
23. TUBE - fuel pickup
12. FITTING 3/8
Fuel System Components for Figure 167
Summary of Contents for UT-1200
