Thermo King UT-1200, Manual

Page: 53 / 169

Operating Instructions for Premium HMI Control Panel
53
IMPORTANT: The ON key must be held down
until the Thermo King Logo appears as shown in
Figure 44. If the ON key is not held down long
enough (approximately ½ second), the display
may flicker but the unit will not start up. If this
occurs, hold the ON key down until the Thermo
King logo appears.
NOTE: With extremely cold ambient
temperatures it may take up to 15 seconds for the
display to appear on initial startup.
Figure 44: Thermo King Logo
Then the startup screen shown in Figure 45
appears while communications are established
and the unit prepares for operation.
Figure 45: Startup Screen
If More Than One Language is
Enabled
If more than one language has been enabled, a
prompt will appear to allow the desired language
to be chosen as shown below. Only languages
enabled from the Guarded Access Menu are
available. If a different language is desired, press
the NO key as shown in Figure 46.
Figure 46: NO key
The Language menu will appear as shown in
Figure 47. Press the + or - keys to select the
desired language. When the desired language is
shown press the YES key to confirm the choice.
Figure 47: YES Key
The display will briefly show PROGRAMMING
LANGUAGE - PLEASE WAIT in the new
language as shown in Figure 48.
Figure 48: Programming Language
The new language is confirmed, and then the
Standard Display will appear in the new language
as shown in Figure 49. The unit is ready to run.
Figure 49: Standard Display
Should it be necessary to change to another
language at any time, return to the Standard
Display and then press and hold the first and last
soft keys for 5 seconds as shown in Figure 50. The
Standard Display below is shown in Deutsche
(German).
Figure 50: First and Last Soft Keys
The Language Menu will appear in the current
language as shown in Figure 51. Press the + or -
keys to select the desired language. When the
desired language is shown press the YES key to
confirm the choice. Note that all languages in the
installed software can be selected using this
method.