Tetra Pak HOYER COMET N, Manual

Page: 73 / 151

7-3
Tetra Pak
Hoyer
CN 02 G A 02
Fig. 7.1
4
2
1
3
5
6
7.2 Regular maintenance
7.2.1 Beginning of the season
• Wash the machine at the end of production
as described in section 7.1. – Washing pro-
cedure, points a, b, c, d and e.
• dismantle dosers and pipes, wash and
disinfect thoroughly;
material required: water – detergent –
disinfectant
• Wash machine thoroughly as described in
section 7.1. – Washing procedure
• dismantle dosers and pipes, wash and
disinfect thoroughly;
• check the condition of the seals, and replace
if necessary;
• lubricate seals;
material required: vaseline oil
• check that the emergency button and
emergency devices are working correctly;
• inspect the machine and tighten any screws
that may have come loose;
• check that there is no leakage at connection
points;
• check the functioning of all moving parts,
and replace if necessary.
7.2.2 Daily maintenance
• lubricate seals, dry components and lubricate
them with neutral vaseline before
reassembling them;
material required: vaseline oil
• check the oil level in the vibrator or twister
doser lubricator container.
g-Save the data and save the washing parameters
in the operating panel, then “Activate the data”
to transfer the PLC format by following the
instructions shown in Chapter 5.
Display the page
C.I.P.
CYCLE : OFF
and proceed as described in Chapter 5 to activate
the washing cycle:
C.I.P.
CYCLE : ON
After the change has occurred, confirm the data
as described in Chapter 5.
Then save the data and the washing parameters in
the operating panel, and afterwards activate the
dosed to transfer the cycle in the PLC.