Tetra Pak HOYER COMET N, Manual

Page: 43 / 151

5-23
Tetra Pak
Hoyer
CN 03 E A 01
DATER
###°
CONSENT: #;START;CAMM:###°;SPEED:###%
DATER START:###° HOMING NOT DONE
###mm ###mm ###mm ###mm ###mm ###mm
###mm ###mm ###mm ###mm ###mm ###mm
20/22
PICK & PLACE
###°
CONSENT : #
START : ###°
LIFT EJECTION : ON= ###° OFF= ###°
21/22
PRODUCT EJECTION
###°
CONSENT : #
START : ###°
EJECTION : ON=### OFF=###°
22/22
upwards/downwards movement of the station
towards the containers. Set ON and OFF values.
To set or edit the data, follow the instructions
provided in
“INSTRUCTIONS ON THE USE
OF THE OPERATOR PANEL TO EDIT OR
ENTER DATA”.
Go to page 20/22 by pressing
pdown
.
The following page will be displayed:
The following parameters for the stamping are
shown this page:
CONSENT: If this value is set to 1, it allows
automatic operation of the station.
Set this value to 1 if automatic operation of the
DATER station of required.
START : Angular value of the ON/OFF
commands whose value is greater than the start
cam. This value is used to define priority of the
ON/OFF commands to be implemented.
SPEED:
speed at which the printing head must
run
DATER START :
actual opening of the printing
head; it is necessary to enter the start and end
values.
###mm (1
st
row): position in mm of the printing
head for each row during forward printing;
###mm (2
nd row): position in mm of the printing
head for each row during the return printing;
The following parameters for the pick & place
device are shown on this page:
CONSENT: If this value is set to 1, it allows
automatic operation of the station.
Set this value to 1 if automatic operation of the
PICK & PLACE station of required.
START CAM: Angular value of the ON/OFF
commands whose value is greater than the start
cam. This value is used to define priority of the
ON/OFF commands to be implemented.
LIFT EJECTION:
Parameters relative to the
downwards/upwards movement of the station
toward. Set ON and OFF values.
To set or edit the data, follow the instructions
provided in
“INSTRUCTIONS ON THE USE
OF THE OPERATOR PANEL TO EDIT OR
ENTER DATA”.
Go to page 2/22 by pressing
pdown
.
The following page will appear:
Go to page 21/22 by pressing
pdown
.
The following page will be displayed:
The following parameters for this station are
shown on this page:
CONSENT: If this value is set to 1, it allows
automatic operation of the station.
Set this value to 1 if automatic operation of the
PICK & PLACE station of required.