Tetra Pak HOYER COMET N, Manual

Page: 41 / 151

5-21
Tetra Pak
Hoyer
CN 03 E A 01
SEALING
###°
CONSENT : #
START : ###°
SEALING DOWN : ON=### OFF=###°
16/22
LID DISPENSER 1
###°
CONSENT : # START=###°
LID RELEASE : OFF=###°sec.
LID DOWN : ON=###° OFF=###°
LID ROTATION : ON=###° OFF=###°
LID VACUUM : ON=###° OFF=###°
LID BLOW : ON=###° ON=###°
17/22
Go to page 16/22 by pressing
pdown
The following page is displayed:
The following parameters for the foil sealing
device are shown on this page:
CONSENT :
If this value is set to 1, it allows
automatic operation of the station.
Set this value to 1 if automatic operation of the
SEALING station is required.
START : Angular value that allows enabling
of the station during automatic start, and disabling
during automatic stop. The value must always be
START : Angular value of the ON/OFF
commands whose value is greater than the start
cam. This value is used to define priority of the
ON/OFF commands to be implemented.
FOIL ROTATION: This parameters is usually not
used. If set with angular values different from 0, it
rotates the foils according to the ON and OFF
values entered. If the ON and OFF values are set
to zero (STANDARD SETTING), foil rotation
will be controlled during the downward
movement, with suction cups oriented down, by
a special external sensor mounted on the station.
During the upward movement of the station, a
second sensor will command foil rotation in the
opposite direction to reorient the suction cups
upwards.
FOIL VACUUM: The ON and OFF parameters
refer to the beginning of the vacuum.
Set vacuum ON to occur before lowering begins,
while the station is rising back up toward the foil
magazine. The vacuum should go off when the
pieces of foil are over the containers.
FOIL BLOW: These settings may be set if
turning the vacuum off is not sufficient to detach
the foils from the suction cups. Set the ON and
OFF values. If both ON and OFF are set to zero,
there will be no blow.
lower than or equal to the lowest of the values set
on this page.
SEALING DOWN: Set ON values (
downward movement ) and OFF values ( upward
movement ).
To set or edit the data, follow the instructions
provided in “INSTRUCTIONS ON THE USE
OF THE OPERATOR PANEL TO EDIT OR
ENTER DATA”. Go to page 17/22 by pressing
pdown
The following page is displayed:
The following is parameters for the lid dispenser
device are shown on this page:
traverse) to bring the lids to the containers. Set
ON and OFF values.
LID DOWN:
Set ON values ( downward
movement ) and OFF values ( upward movement
).
LID ROTATION:
This parameter is normally
not used. If set with angular values different from
0, it rotates the lids according to the ON and OFF
values set. If ON and OFF values are set to zero,
(STANDARD SETTING), lid rotation will be
controlled during station downwards movement
by a special external sensor placed on the station,
orienting the suction cups down. During the
upwards movement of the station a second sensor
will command lid rotation in the opposite direction
to orient the suction cups upwards again.
LID VACUUM: ON and OFF parameters refer
to the beginning of the vacuum.