Tetra Pak HOYER COMET N, Manual

Page: 42 / 151

5-22
Tetra Pak
Hoyer
CN 03 E A 01
LID DISPENSER 2
###°
CONSENT : #
START=###°
LID RELEASE :
ON=###° OFF=###°
LID DOWN : ON=###° OFF=###°
18/22
CRIMPER
###°
CONSENT : #
START : ###°
CRIMPER DOWN : ON=### OFF=###°
19/22
Set vacuum activation so that it occurs before the
downward movement begins, specifically when
the station is moving up to the lid magazine.
Vacuum must be disabled when the lids are
above the containers.
LID BLOW: These parameters may be set if
disabling of the vacuum is not sufficient, in order
to allow detachment of the lids from the suction
cups. Set ON and OFF values. If ON=0 and
OFF=0 are set, no blow will occur.
These parameters may also be used if opening/
closure of the slave cylinders need to be controlled
by a cam control rather than by a time control. In
this case the blow function is not used.
To set or edit the data, follow the instructions
provided in
“INSTRUCTIONS ON THE USE
OF THE OPERATOR PANEL TO EDIT OR
ENTER DATA”.
Referring to the instructions provided in
paragraph 6 “Lid/foil dispenser station”, set the
following parameters on this page:
CONSENT:
If this value is set to 1, it allows
automatic operation of the station.
Set this value to 1 if automatic operation of the
FOIL DISPENSER station of required.
START : Angular value of the ON/OFF
commands whose value is greater than the start
cam. This value is used to define priority of the
ON/OFF commands to be implemented.
LID RELEASE: This parameter is to be set only if
cup lids are to be dispensed, otherwise the value of
0,00 sec. should not be edited. If this is the case, a
special proximity sensor placed on the cylinder for
upwards movement of the station controls the
beginning of slave cylinder opening (Part. 8, Fig.6.13)
used to hold/release the lids. The time that can be set
in this field represents the delay of cylinder closure,
i.e. the duration of cylinder opening.
LID DOWN: Parameters relative to downwards/
upwards movement of the station.Set ON values
( downward movement ) and OFF values ( upward
movement ).
To set or edit the data, follow the instructions
provided in
“INSTRUCTIONS ON THE USE
OF THE OPERATOR PANEL TO EDIT OR
ENTER DATA”.
Go to page 19/22 by pressing
pdown
.
The following page will be displayed:
Go to page 18/22 by pressing
pdown
.
The following page will be displayed:
The following parameters for the crimper are
shown on this page:
CONSENT: If this value is set to 1, it allows
automatic operation of the station.
Set this value to 1 if automatic operation of the
CRIMPER station of required.
START:
Angular value that allows enabling
of the station during automatic start, and disabling
during automatic stop. The value must always be
lower than or equal to the lowest of the values set
on this page.
CRIMPER DOWN: Parameters relative to