Tetra Pak HOYER COMET N, Manual

Page: 28 / 151

5-8
Tetra Pak
Hoyer
CN 03 E A 01
C.I.P.
CYCLE: OFF
ON/OFF: 00 sec.
TIME: 0 min.
SEALING UNIT 6
ACTUAL (°C): 20.0
SET POINT (°C): 85_0
HYSTERESIS (°C):
STATE: OFF
15/15
clr
to go back to the first page of the function
keys.
F10
:
C.I.P. DATA SETTING
This key is exclusively used to set washing cycle
parameters. This operation can be performed
only when the machine is at a standstill.
Therefore, if the machine was started in
automatic mode, press
F4
to stop the stations
in sequence and
F1
to stop the main motor.
The next page appears after pressing
F10
.
To set data proceed as follows:
- press to make the cursor flash on the ON/
OFF field and enter the valve opening time for
inlet of the washing liquid.
- press to shift the cursor to the TIME field
and enter the total duration of the C.I.P. cycle.
Confirm by pressing
Enter
.
- press
F4
to start all dosers on the machine.
The A2 key led will turn to green, showing that
the bypass valve is closed. ( The washing liquid
will flow through the dosers only ).
For the entire duration of the washing the C.I.P.
page will be displayed and the CYCLE value will
be displayed ON. At the end, once the set time
has elapsed, that value will change from ON to
OFF.
At the end of the washing cycle, to leave the C.I.P.
page press
clr
.
Data setting instructions are the same as those
described earlier.
ACTUAL: Temperatre detected on sealing plate
No. 1
SET POINT: Required working temperature.
HYSTERESIS: Differential hysteresis value.
STATE: Sealing station status (ON= heating,
OFF= required temperature reached).
Once you have finished entering data press