Terex Genie Z-40, Service And Repair Manual

Page: 98 / 287

Service and Repair Manual June 2022
Track Components
84 Z ® -62/40 Part No. 1268555GT
6 Install the new track onto the undercarriage.
7 Attach a lifting strap from an overhead
supporting device to the center-point of the
track, above the sprocket.
8 Use the overhead supporting device to raise
the track assembly to an upright position.
Rest the assembly on the floor or ground to
remove any slack in the lower portion of the
track.
Note: Be sure the idler and bogey wheels are
aligned with the inside surface of the track.
1 idler wheels
2 bogey wheels
9 Rotate the sprocket half until the split tooth of
the sprocket is lower than the other side.
1 split tooth
10 Using an overhead supporting device, lift up
on the rubber track to create enough room to
install the other sprocket half.
11 Install the sprocket half, removed in step 3,
while engaging the sprocket teeth with the
rubber track.
Note: Be sure to align the split tooth in both of the
sprocket halves.
12 Insert a pin or rod through the wheel stud hole
closest to the split tooth to hold the sprocket
in place.
13 Insert a pointed pry bar into the wheel stud
hole near the top of the sprocket. Insert
another pointed pry bar into the wheel stud
hole at the opposite side of the split tooth.