Terex Genie Z-40, Service And Repair Manual, Page: 101 / 287

June 2022 Service and Repair Manual
Generators
Part No. 1268555GT Z ® -62/40 87
Genera tors
12-1 Hydr aulic G ene rato r 12-1
Hydraulic Generator
How to Purge the Hydraulic Line
on the MTE Generator
Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
Note: This procedure should be performed if the
hydraulic line to the generator has been removed.
Note: Perform this procedure with the machine on
a firm, level surface.
1 Locate the blue purge wire with the male
spade connector from the MTE generator
harness.
2 Connect a jumper wire of sufficient length
from the positive battery terminal to the spade
connector on the purge wire.
3 Start the engine and turn on the generator.
Allow the generator to run for three minutes.
4 Turn off the generator and turn off the engine.
5 Remove the jumper wire from the positive
battery terminal and disconnect from the
purge wire.
6 Start the engine and turn on the generator.
Using a digital multimeter check the voltage at
the outlet.
Result: The generator produces a voltage
±10% of rated output. The generator is ready
for use.
Result: The generator output voltage is
outside the ±10% voltage range. Repeat the
procedure beginning with step 2.