41
7. Filters:
7.1 Median Filter (On)
7.2 Average Filter (On)
7.3 Decimal Point Position
It shows the location of the decimal point on the unit weight display. If the number is “ 0 ”
point is at the rightmost side. If it is “ 5 “ point is at the leftmost side.
8. Calibration:
8.1 Calibration Coefficient
It can be changed only if the calibration key is ON.
8.2 Maximum Capacity
It can be changed only if the calibration key is ON.
8.3 Division (1)
0: 3000
1: 2 x 3000
2: 3 x 3000 (not valid for approved models)
3: 6000 / 7500 (not valid for approved models)
4: 12000 / 15000 (not valid for approved models)
6: 1500 (It can be changed only if the calibration key is ON.)
8.4 Load Cell Maximum Capacity
It can be changed only if the calibration key is ON.
8.5 Device Unit (1)
0: g
1: kg
2: ton
It can be changed only if the calibration key is ON.
8.6 Gravity (“G”) value of the location where scale is calibrated (9.8022)
It can be changed only if the calibration key is ON.
8.7 Gravity (“G”) value of the location where scale will be used (9.8006)
It can be changed only if the calibration key is ON.
8.8 Load Cell mV/V value
mv/V value of the Load Cell used.
9. Relay Settings:
Not valid for this model.
10. Interface Settings:
(Valid only for PRINTER/PC type scales)
Summary of Contents for EX10200006
