![background image](http://html.mh-extra.com/html/tem/ex10200006/ex10200006_user-manual_1085228019.webp)
18
SILO MODE
Only TEB series models have this feature.
To enable Silo Mode, 12.1 must be OFF (non-approved mode) and 2.7 must be ON (Silo Mode
is Active)
In this mode Initial Zero Setting Control is not applied. It displays the same weight value after
the device is turned off and turned on.
Zero setting key does not work in this mode. For zero setting, press three times Zero key for
3 seconds.
DISPLAY BACKLIGHT
Press
☼
key to toggle between backlight ON, OFF and ON_OFF modes.
To change backlight mode:
Press
☼
key. Backlight mode will be displayed for 1 second.
bL On
: Backlight ON. Backlight is permanently ON.
bL OFF
: Backlight OFF. Backlight is permanently OFF.
bLOnFF
: Backlight ON_OFF. Backlight is ON while weighing or pressing a key. Backlight is
OFF when there is no weight on the weighing plate.
When scale is turned on, backlight mode is OFF. If there is a flashing dot on display instead of weight
value, backlight will be turned off automatically.
LIMITATION
When this function is activated, an acoustic signal is generated between the two predefined weight
values. To use this feature; go to Set 4.1 to set the minimum weight value limit and go to Set 4.2 to set
the maximum weight value limit. To activate this function, Set 4.3 must be ON.
Example: To set the maximum weight value limit to 2kg follow the below steps;
1.
Press F key for 3 seconds. Set 1.1 will be displayed for 2 seconds and the corresponding value
will be displayed for 2 seconds repeatedly.
2.
Press F key 3 times to go to menu 4.1. Set 4.1 will be displayed for 2 seconds and the
corresponding value will be displayed for 2 seconds repeatedly.
3.
Press Zero key once to go to Set 4.2. Set 4.2 will be displayed for 2 seconds and the
corresponding value will be displayed for 2 seconds repeatedly.
4.
Press MR/MC key. First digit on the rightmost starts flashing. Press M+ key to change the
value to “0”. “XXXXX0” will be displayed.
5.
Press MR/MC key. Second digit from the right starts flashing. Press M+ key to change the
value to “0”. “XXXX00” will be displayed.
6.
Press MR/MC key. Third digit from the right starts flashing. Press M+ key to change the value
to “0”. “XXX000” will be displayed.
7.
Press MR/MC key. Fourth digit from the right starts flashing. Press M+ key to change the
value to “2”. “XX2000” will be displayed.
Summary of Contents for EX10200006
