144
16.7
AutoCAN Configuration over SMS
16.7.1
SMS command format:
“<login><space><password><space>setparam<space><profile number><Element
ID><space><Element format>”
if there is no login and password configured in FM configuration, 2 spaces must be used
before command :
<space><space><command>.
Element format:
<SendDataToServer>,<HighLevel>,<LowLevel>,<DataAcquisitionType><averaging constant>
Element format values:
<[0-7]>,<int32>,<int32>,<[0-5]>,<int32>
For example: <space><space>setparam 3347 2,70,50,3,10
Here we set
FMB630
to make a high priority event once the
FMB630
either reaches higher than
70km/h speed or starts going lower than 50km/h.
**If we want to configure FMB630 to make a panic event everytime brake pedal is either
pushed or released, the SMS we would have to send is:
<space><space>setparam 3346 3,0,0,1,10 (here we skip HighLevel and LowLevel so we write 0)
16.7.2
AutoCAN element Id‘s
Table 59 AutoCAN element Id‘s
Category name
Element ID
Element name
Cruise Control/Vehicle Speed
346
Brake switch
347
wheel based speed
348
cruise control active
349
clutch switch
350
PTO state
Electronic Engine Controller #2
351
Accelerator pedal position 1 X
352
Engine Percent Load At Current
Speed X
Fuel Consumption
353
Engine total fuel used
Dash Display
354
fuel level 1 X
Electronic Engine Controller #1
355
Engine speed X
Vehicle Weight **
356-370
Axle location
Tire location
Axle weight
Engine Hours, Revolutions:
HOURS
371
Engine total hours of Operation
X
Vehicle Identification
372
vehicle identification number X
FMS Standard interface
373
SW-version supported X
374
Diagnostics supported X
375
Requests supported X
High Resolution Vehicle Distance
376
High resolution total vehicle
distance X
Service Information
377
Service distance
Tachograph
378
Vehicle motion X
