Televes 769501, User Manual

Page: 162 / 196

162
GPON ONT
7.2.1.5.2 “remove” command
Name remove
Description Removes an existing IPoE service
Full path /wan/ipoe/remove
Arguments
<MANDATORY>
--if-to-rmv WAN Interface
Table 7-7: “remove” command information
7.2.1.6 “pppoe” sub-node
7.2.1.6.1 “create” command
Name create
Description Creates a new PPPoE service
Full path /wan/pppoe/create
Arguments
<MANDATORY>
--interface Interface
[OPTIONAL]
--auth-error-retry Authentication error retry <enable|disable>
(disable by default)
--auth-method Authentication method <AUTO|PAP|CHAP|MSCHAP>
(AUTO by default)
--debug PPP Debug Mode <enable|disable> (disable by default)
--dhcp6c-iana Launch Dhcp6c for Address Assignment (IANA)
<enable|disable> (disable by default)
--dhcp6c-iapd
Launch Dhcp6c for Prefix Delegation (IAPD)
<enable|disable> (enable by default)
--firewall
Firewall <enable|disable> (disable by default)
--fullcone Fullcone NAT <enable|disable> (disable by default)
--igmp IGMP Multicat Proxy <enable|disable> (disable by default)
--igmp-mcast-src IGMP Multicast Source <enable|disable> (disable by de-
fault)
--ipv4-add
Static IPv4 Address
--ipv6-add Static IPv6 Address
--ipv6-unnumbered-model IPv6 Unnumbered model <enable|disable>
(enable by default)
--mld MLD Multicat Proxy <enable|disable>
(disable by default)
--mld-mcast-src MLD Multicast Source <enable|disable>
(disable by default)
--ip-version Network Protocol <ipv4|ipv6|dual> (IPv4 by default)
--no-mcast-vlan-filter Multicast VLAN Filter <enable|disable> (disable by default)
--on-demand
Dial on demand (with idle timeout timer) <enable|disable>
--password PPP Password
--pbit 802.1P Priority [0-7] (-1 by default)
--server-name PPPoE server name
--service-name Service description
--timeout Inactivity Timeout (minutes) [1-4320]
--to-bridge Bridge PPPoE Frames Between WAN and Local Ports
<enable|disable> (disable by default)
--tpid VLAN TPID <0x8100|0x88A8|0x9100> (-1 by default)
--username PPP Username
--vlan 802.1Q VLAN ID [0-4094] (-1 by default)
Table 7-8: “create” command information