Televes 769501, User Manual

Page: 64 / 196

64
GPON ONT
5.6.2.2.1.2 Use of Static IP Address
STEP 1. Select the option “Use the following Static IP address “, option 2 of Figure 5-43.
STEP 2. Enter WAN IP address to be used
Enter WAN Subnet Mask to be used;
Enter WAN gateway IP Address to be used
STEP 3. Use the Next button to progress to the WAN Service setup window- Network Address Translation Settings configuration
1
2
XPTO
Figure 5-43: WAN Service setup window- WAN IP Settings configuration
5.6.2.2.2 Network Address Translation Settings
To use NAT, option “Enable NAT” must be selected, Figure 5-44; If NAT option is selected, the option Fullcone NAT is available; if selected a warning
message on the disadvantages of its use is shown, Figure 5-45.
To use Firewall option “Enable Firewall” must be selected, Figure 5-44.
In this window is also possible to configure IGMP Multicast as Proxy by selecting option “Enable IGMP Multicast Proxy” or as a Source by selecting
option “Enable IGMP Multicast Source” and enable/disable Multicast VLAN filter, Figure 5-46.
ArPing Setup allows ArPing to be enabled and the number of repetitions and timeout to be configured. To configure ArPing “Enable ArPing” Op-
tion must be selected, Figure 5-47, and the values for number o repetitions and timeout interval (seconds) must be entered. ArPing is similar to
Ping as given an IP address it test to find out if this is in use on the local network, and can get additional information about the device using that
address.