Tektronix DPO2304SX, Printable Help

Page: 357 / 920

Set up USB search parameters
After setting up an USB bus, go to the Analyze menu, select Search, and then select the Bus trigger type; then open the
Configure tab.
Overview
Use the controls to set up the USB Bus parameters.
To use
For information on the controls, click the buttons.
■ Type
■ Source
■ Copy Settings
■ Search Parameters
■ Search / Mark Controls
Behavior
Clicking an entry in the Type column activates the individual search controls, similar to the one shown above. These controls vary
depending on the search Type. Setting the search conditions is similar to setting the parameters for an
Event Trigger .
NOTE. No information will be displayed in this window until you specify at least one search Type in the
Search Select Control
Window .
To use
■
Click the Source box and select the bus number or name from the window. Bus Search Selection List
■
Select the type of bus cycle or activity to search for from the Search For drop-down list.
Analyzing waveforms
DPO70000SX, MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO5000B Series 325