Tektronix CMD 80, User Manual

Page: 114 / 672

CDMA: Configuration
CMD 80 Digital Radiocommunication Tester User Manual
3–49
Press this softkey to select the configuration menus for the CDMA manual tests.
You can use these menus to establish the parameters for those tests done while in
the CDMA Manual Test mode.
Press this softkey to select the configuration menus for the CDMA module tests.
Use this menu to set the parameters for the CDMA Module Test mode.
Press this softkey to select the CDMA BS SIGNAL CONFIGURATION menu
for the CDMA tests. Use this menu to define the components of the base-station
signal. These include the levels of the pilot, sync and paging channels, and other
components, such as traffic channel and frame offset. You can use this menu to
specify the default RF channel. Table 3–4 on page 3–50 lists the valid CDMA
channels.
NOTE
. The level settings set in the BS SIGNAL CONFIGURATION menu are the
system default levels unless overridden by a test. For example, the receiver
sensitivity test overrides the traffic and pilot level values with the parameters
established for the receiver sensitivity test.
CDMA BS Parameters.
This softkey displays a submenu of the CDMA BS
SIGNAL CONFIGURATION MENU. You can use this menu to specify
parameters for the simulated base station (default values are available).
Press the CDMA BS PARAMETERS softkey to display the CDMA BS
PARAMETERS CONFIGURATION menu.
If you have selected US Cellular or PCS (upbanded IS-95) as the network, you
can select one of the following protocols from the CDMA BS PARAMETERS
CONFIGURATION menu:
H
PROTOCOL REVISION 1 (IS-95)
H
PROTOCOL REVISION 2 (IS-95A)
H
PROTOCOL REVISION 3 (TSB-74)
You can also select the mobile identification type. Press the MOBILE ID TYPE
softkey to select either the MIN or IMSI. The mobile ID provides the tester with
the necessary information so that you can use the CALL TO MOBILE softkey in
the MS UNREGISTERED menu. (Refer to Figure 3–4 on page 3–7 and CALL
TO MOBILE on page 3–9). The MOBILE ID TYPE specifies the format of the
mobile ID as either Mobile Identification Number (MIN) or International Mobile
Station Identification (IMSI).
Manual Test
Module Test
CDMA BS Signal Cnfg
Protocol Revision
Mobile ID Type